CHARTER ARMS REVOLVERS REVIEW PROFESSIONAL

cartridges for casual plinking or target practice. chambering allows for the use of soft-shooting. ProfessionalВ is a rugged, simple revolver that is an affordably priced option suitable for concealed carry or home defense. The revolver proved to be utterly reliable with all of the ammunition tested, and it operated properly throughout testing with no mechanical issues or misfires. The cylinder yoke was a bit stiff to swing out, but the cylinder would spin freely once opened.

CHARTER ARMS REVOLVERS REVIEW PROFESSIONAL

357 cartridges, and the Professional is no exception however, the smooth walnut stock helps the gun to roll back in the shooting hand, which in turn works to help manage felt recoil. Lightweight revolvers can be a handful when firing full-power. Many Charter guns ship with compact rubber stocks this model ships with a fullsize, smooth walnut stock with bilateral thumb rests, a curved backstrap and finger grooves along the front. The fixed front sight blade is milled down and replaced with a bright green fiber-optic pipe in a square housing that preserves the sight picture formed with the square-notch rear sight. It also toughens the bore for an increased working life and reduces the friction between moving parts. The entire gun has been treated to Charter ArmвЂ™s proprietary Blacknitride+ finish that increases the hardness of the surface for improved wear and scratch resistance. Manually cocking the hammer for single-action fire resulted in a trigger pull of 3 lbs., 15 ozs.ДЄs a member of the ProfessionalВ line, this revolver enjoys a few upgrades not found on the standard Bulldog models. or greater with a rough or stacking trigger pull the trigger of the Professional tested exhibited a smooth double-action trigger pull of 10 lbs., 2 ozs. The double-action trigger pull of some revolvers can be 12 lbs. The rounded trigger guard houses a curved trigger with a grooved face. Sights on the Professional consists of a fixed, green fiber-optic pipe up front and a square-notch rear that has been cut into the revolverвЂ™s frame. A cylinder stop on the frame is not required, which aids in quicker reloads when using a speedloader. The cylinder is supported by a three-point lockup it rotates clockwise and swings out to the left side when the flat, serrated cylinder release is pressed forward toward the muzzle. The cylinderвЂ™s yoke is fitted into a protective slot in the frame rather than being exposed along its front edge like some other designs. A frame-mounted transfer bar safety, located between the hammer and the firing pin, prevents the revolver from firing if dropped.

It is positioned relatively low to make it easier to reach with the thumb of the shooting hand. The grooved cocking spur of the hammer is relatively short, which reduces the chance of it snagging on clothing. The topstrap of the receiver is deeply grooved with a square notch above the hammer to form the rear sight. The full-length, flat-sided under lug shrouds the spring-loaded ejector rod, while the front sight base is a milled extension of the barrel. The bore is button-rifled with eight grooves, instead of six, to provide a better gas seal and reduce bullet deformation. The one-piece 3вЂі barrel shares the same profile as other Charter models currently in production. Like other Charter Arms models, the ProfessionalвЂ™s trigger guard and grip assembly are made of lightweight aluminum.

Charter arms revolvers review